SEER Rating Savings Calculator

Estimate annual energy cost savings from upgrading to a higher SEER-rated air conditioner or heat pump, factoring in tonnage, annual cooling hours, and local electricity rates. Free online calculator for comparing SEER 13 through SEER 21+ systems before an upgrade decision, no sign-up required.

Capacity unit

Result

Old annual cost

810.00

New annual cost

506.25

Annual savings

303.75

Percentage reduction: 37.5%

This is a simplified estimate assuming the same capacity and usage hours for both units. Actual savings depend on installation quality, usage patterns, and your utility's rate structure.

Usage examples

Estimating savings from replacing an old AC unit

See roughly how much a 3-ton (36,000 BTU/hr) unit would save per year when upgrading from SEER 10 to SEER 16.

Adjusting cooling hours for your climate

If you live somewhere hot or run your AC heavily, increase the annual cooling hours input for a more realistic savings estimate than the generic default.

Comparing different SEER ratings before buying

Try a few different new-unit SEER values to see which rating offers savings that reasonably justify the extra upfront cost.

Evaluating a minimum-efficiency SEER 13 to SEER 20 heat pump upgrade

Enter a 4-ton (48,000 BTU/hr) system, SEER 13 for the old unit, SEER 20 for the new one, 1200 annual cooling hours, and your local $/kWh rate to see the potential savings from jumping to a high-efficiency heat pump.

Comparing a mid-range SEER 14 to a premium SEER 21 variable-speed unit

For a 2.5-ton (30,000 BTU/hr) condo system, compare SEER 14 against SEER 21 at around 900 annual hours to see whether a premium variable-speed compressor's savings justify its higher price over a standard single-stage unit.

Estimating savings in a hot, high-usage climate like Phoenix or Houston

Set annual cooling hours to 1800 or more for a 3.5-ton unit upgrading from SEER 11 to SEER 17, reflecting the long cooling season typical of hot southern climates.

Estimating savings in a mild, low-usage climate

Set annual cooling hours closer to 500-600 for a 2-ton unit upgrading from SEER 12 to SEER 16, reflecting a mild coastal or northern climate with a short cooling season.

Adjusting for a higher local electricity rate

Replace the default $0.15/kWh with a higher regional rate like $0.30/kWh (common in parts of California or the Northeast) to see how much more valuable the SEER upgrade becomes where electricity is expensive.

Quick reference

Annual cooling cost by system size and SEER — 1500 cooling hours/year, 0.15 per kWh

System sizeSEER 10SEER 13SEER 14SEER 16SEER 18SEER 20
1.5 ton (18,000 BTU/hr)405 (2,700 kWh)312 (2,077 kWh)289 (1,929 kWh)253 (1,688 kWh)225 (1,500 kWh)203 (1,350 kWh)
2 ton (24,000 BTU/hr)540 (3,600 kWh)415 (2,769 kWh)386 (2,571 kWh)338 (2,250 kWh)300 (2,000 kWh)270 (1,800 kWh)
2.5 ton (30,000 BTU/hr)675 (4,500 kWh)519 (3,462 kWh)482 (3,214 kWh)422 (2,813 kWh)375 (2,500 kWh)338 (2,250 kWh)
3 ton (36,000 BTU/hr)810 (5,400 kWh)623 (4,154 kWh)579 (3,857 kWh)506 (3,375 kWh)450 (3,000 kWh)405 (2,700 kWh)
3.5 ton (42,000 BTU/hr)945 (6,300 kWh)727 (4,846 kWh)675 (4,500 kWh)591 (3,938 kWh)525 (3,500 kWh)473 (3,150 kWh)
4 ton (48,000 BTU/hr)1,080 (7,200 kWh)831 (5,538 kWh)771 (5,143 kWh)675 (4,500 kWh)600 (4,000 kWh)540 (3,600 kWh)
5 ton (60,000 BTU/hr)1,350 (9,000 kWh)1,038 (6,923 kWh)964 (6,429 kWh)844 (5,625 kWh)750 (5,000 kWh)675 (4,500 kWh)

SEER upgrade savings — 3 ton system, 1500 cooling hours/year, 0.15 per kWh

Old unit SEERNew unit SEERAnnual savingsPercentage reduction
SEER 8SEER 14434 / year42.9%
SEER 10SEER 14231 / year28.6%
SEER 10SEER 16304 / year37.5%
SEER 10SEER 18360 / year44.4%
SEER 13SEER 16117 / year18.8%
SEER 13SEER 18173 / year27.8%
SEER 13SEER 20218 / year35%
SEER 14SEER 1672 / year12.5%
SEER 14SEER 18129 / year22.2%
SEER 16SEER 20101 / year20%

Frequently asked questions

How do I pick the right annual cooling hours?

So-called 'full cooling load hours' vary enormously by climate zone, roughly from 500 hours a year up to 1500 or more. The provided default is just a generic starting point — you should adjust it to match your actual climate and how heavily you run your AC.

Does this guarantee I'll save exactly this much?

No. This is a simplified estimate that assumes identical cooling capacity and usage hours for both units. Real-world savings can differ due to duct leakage, installation quality, weather variation, and tiered electricity pricing.

How does tonnage relate to BTU/hr?

In cooling capacity, one ton equals 12,000 BTU/hr. Residential AC units are commonly labeled in either tons or BTU/hr.

Where does the default electricity rate come from?

It's just a rough US-average-ish placeholder — actual rates vary a lot by region and season. Always replace it with the rate shown on your own utility bill.

What does SEER actually measure?

SEER (Seasonal Energy Efficiency Ratio) is the ratio of total cooling output (in BTU) delivered over a typical cooling season to the total electrical energy input (in watt-hours) over that same season. A higher SEER means the unit delivers more cooling per unit of electricity, similar to how a higher MPG rating means a car travels farther per gallon of fuel.

What's the difference between SEER and SEER2?

SEER2 is a revised testing standard introduced in 2023 that uses a different external static pressure during testing, producing ratings that are generally a few percent lower than the equivalent SEER rating for the same physical unit. If you're comparing a newer SEER2-rated unit to an older SEER-rated one, the numbers aren't perfectly apples-to-apples — check both figures when comparing older and newer equipment.

Is it worth upgrading from a working but low-SEER unit before it fails?

This depends heavily on your annual cooling hours, local electricity rates, and the remaining lifespan of the old unit. Use this calculator to estimate annual savings, then compare that figure against the installation cost of early replacement versus just running the old unit until it fails and replacing it then — in mild climates with cheap electricity, the payback period can be quite long.

Does a higher SEER rating always mean better comfort, not just lower bills?

Not necessarily on its own — SEER measures seasonal energy efficiency, not comfort features like humidity control or temperature consistency. Many high-SEER units do pair efficiency gains with variable-speed or multi-stage compressors that improve comfort, but a high SEER rating by itself only tells you about energy use, not airflow quality or dehumidification performance.

Why does the calculator need the old unit's SEER if it's being replaced anyway?

The savings estimate is a comparison: it calculates the annual electricity cost of running the old, less efficient unit against the annual cost of the new one at the same capacity and usage hours, then reports the difference. Without the old unit's SEER, there's no baseline to measure savings against.